Keg Dispensing Supplies

If you have a Perlick lever sanke coupler with bad shaft o-rings, we've got you covered! These fit in the shaft of the Perlick lever coupler, stabilizing the shaft and allowing complete functionality. Have a few extras on hand just in case!

Most often used for CO2 connections, these quick disconnects are chrome-plated brass. This is the male side, which has a 3/8" straight barb on one end, while the other end is male andfits into the female end. It has a temperature tolerance range from -40 to 180F and a vacuum pressure tolerance of 120 PSI. This male piece is used with the female piece #04P01-111

Beer shanks to make all your dispensing dreams come true! These chrome plated brass shanks are used in a variety of setups to create draft systems. A 3/16" bore is perfect for liquid dispensing of all types, including sweet sweet beer. This 5" shank (actual measurement: 5 1/8") is slightly longer than the standard 4" shank and works when you need just a little more length. Simply drill out your hole, place your shank through, and lock in place with the included lock nut. A faucet can then be attached to the outside of your draft setup, whether it be a kegerator, keezer or jockey box! Also needed on the inside is a 3/16" tailpiece, neoprene beer washer and beer nut.